You are watching: 2007 nissan altima transmission fluid change
Tools/supplies Needed:Pliers10mm Allen Wrench, T-handle1.5 ft. Of clear functional tubing (1 in. Diameter)Container significant of f at 1 qt. (did this v a measure up cup and sharpie marker)Collection pan to collect the used transmission fluidFlat Head ScrewdriverTransmission fluid Funnel endure needed: I would say some endure working on cars, in ~ least have the ability to do your own oil changes prior to you try to perform this. Friend will likewise need one person roughly to help.
Step 1: journey car around for about 10 minutes to warm everything up. Park it, run v all the gears (P, R, N, D, and then back to P) and leave the engine running. Traction the infection dip stick out, wipe clean, insert ago in however rotate 180 degrees and push every the way down. Pull ago out and also check the level (remember whereby it is for this reason you have the right to refill earlier to same location, have to be in ~ the 2nd notch). This is likewise where you will include transmission fluid.
Step 2: advanced the front finish of the vehicle somehow. I have small ramps I use for transforming my oil so i drove increase onto these. Turn off the car.Step 3. With the dive stick traction out. Ar a arsenal pan underneath the transmission drainpipe plug. Using the hex screwdriver/tool, unscrew the drainpipe plug. An alert that the doesn’t take much force to unscrew this for this reason don’t end tighten once putting back on. Allow all of the liquid to drain, i left it to drain for about 15 min.
Step 4. Screw the drain plug earlier on. Ns think you have the right to replace the o-ring ~ above the drainpipe plug yet I didn’t execute this.Step 5. Measure just how much fluid you drained the end by making use of your container that you significant off at 1 qt. Ns drain around 4.5 qts. Include the same amount of fluid you took out back into the transmission with the recharging pipeline (same location you pulled the dip rod out) making use of your funnel.
Step 6. Eliminate the wheel well splash guards indigenous the driver’s next wheel (be careful with the tabs holding this on, easy to break). Take her time a pry lock off progressively with a flat head screw driver. Remove to disclose the transmission liquid inlet harbor (where liquid comes in indigenous the radiator).
Step 7. Using your pliers, squeeze and slide turn off the water tap clamp holding the pipe onto the inlet port.
Step 8. Ar the pipe you remove right into your 1in. Diameter clear plastic tube. Straight it into your container marked at 1 qt.Step 9. Have actually a friend start your car. Allow it come run until you have removed 1 qt. That fluid and also then revolve the automobile off.
Step 10. Include a qt. Of brand-new fluid earlier into the infection (to change the qt. You flushed out).Step 11. Repeat measures 9 and also 10 till you’ve built up a replaced about 6 qts. Of fluid. It begin to gain clean about 5 qts. I did an extra one for an excellent measure.Step 12. Reconnect your hose come the transmission inlet port and also using her pliers, squeeze out the water tap clamp and also slide it ago onto the hose. This is the hardest part of the entirety thing, trying the obtain that stupid clamp ago on.Step 13. Start the car and also let it operation for a minute. Walk around and also check for any type of leaks.Step 14. Lower the auto down. Run it ago through every the gears and check the liquid level just as before. Change the liquid as needed. Step 15. Ar the splash guards earlier on and that’s it. You room done.
2007 Nissan Altima 3.5 SE w/ CVT at sight Black27% tint all aroundK&N drop in filterStillen Cat-back Exhaust2006 Nissan 350Z 6-Speed hand-operated Super Black
Roughly just how long does it require to pump out one quart? That liquid looks quite nasty. I"m pull close 30k. I"m gonna walk ahead and readjust fluid then. This doesn"t sound hard at all.
About 7 seconds to pump the end a qt. Of liquid so not long at all. All at once i choose the triple treads, but you feeling a the majority of road vibrations through them. I come off of S-drives which were very smooth and quiet but bad tread life. This are certainly not as soft the a tire, yet they do come v a much longer tread life. Great dry traction and also excellent in the rain, even the hefty stuff ive had actually zero troubles with traction.
2007 Nissan Altima 3.5 SE w/ CVT at sight Black27% tint all aroundK&N fall in filterStillen Cat-back Exhaust2006 Nissan 350Z 6-Speed hand-operated Super Black
Nice job, thanks for the effort. Ns think you space the first here to carry out this job.So, you offered 11 qts of liquid for the swap? (4.5 top top the drain, 6 an ext on the flush)I"m early out in an additional 19k (2nd tranny will be at 60k), for this reason probably about mid-February.
About 7 seconds to pump the end a qt. Of liquid so not long at all. In its entirety i prefer the triple treads, but you feeling a the majority of road vibrations through them. I come off of S-drives i m sorry were an extremely smooth and also quiet but negative tread life. This are certainly not as soft the a tire, however they execute come with a much much longer tread life. An excellent dry traction and excellent in the rain, even the heavy stuff ive had actually zero troubles with traction.
Yea they to be designed to give you all the traction, however they not ride as smooth. The was the number one complaint I obtained when selling them, but most world didnt mind because of how great they are in every weather. I was suprised how an excellent they space in the snow.
CVT liquid changeThanks dagreek ! that was a good job through you. Is that a filter sort of point where the inlet port was hooked ? Again ! good job! :shift:
I"ve never adjusted the fluid in any car I"ve owned with an auto trans. I recognize you deserve to do it, however the problem I have actually is the the fluid in the talk converter is not drained unless you pump the out. The procedure explained here is nice close to the procedure in the shop manual, other than that Nissan wants you to perform the complete fluid change with the engine running. Castle (Nissan) state that it will certainly take around 50% "extra" liquid to do the washing up completely. Probably that takes treatment of the torque converter- ns don"t know. But the fluid in an auto infectious diseases world fashion lasts therefore long, it"s not a large savings to carry out it yourself, even though the dealer will certainly "overcharge" for the CVT fluid.
I check out the clear tube, why did girlfriend hook the red hose to the inlet port and what"s on the other finish of it?
Sure, friend can include it to the FAQ Forum. Bikerider, that hose i placed on the inlet just in case fluid come out the it, yet none did so it ~ no needed, ns was just being cautious.Ormand, i usually did carry out it through the automobile running, i simply turned the auto off after each qt. To store up with the pump.
2007 Nissan Altima 3.5 SE w/ CVT at sight Black27% tint all aroundK&N autumn in filterStillen Cat-back Exhaust2006 Nissan 350Z 6-Speed hand-operated Super Black
Can someone please update this with pictures. I"m do the efforts to do this on mine 09 with 2.5. Complete flush because my vehicle was flooded. I dislike it when world use these stupid ignorant hosting websites. Just upload it directly on the forum so details won"t be lost.
See more: What Is 36.5 Celsius In Fahrenheit, Your Body Temperature Is 36
Welcome to Nissan Club, among the biggest Nissan forum communities. Discussion, reviews, maintenance and also more.
2002-2006 Nissan Altima conversation (2.5 & 3.5)2007-2012 Nissan Altima conversation (2.5 & 3.5)General Nissan Altima discussion (1993-2001)2013-2018 Nissan Altima discussion (2.5 & 3.5)Engine performance (2002-2006)