*
*
A pair that jack stands
*
*
*
A jack come lift the car
*
*
Genuine 5149098AA Oil pressure Switch
*
*
*
1/2-Inch journey 27mm deep socket
*
*
*
1/2-Inch drive ratchet
*
*
*
A 1/2-Inch global joint
*
*
*
Eventually a 1/2-Inch drive extension bar
*
*
*
15mm wrench
*

*
A defective oil push sensor switch may cause an oil leak. The oil light may come on and a P0522 error code can be read on her OBD-2 scan tool.

You are watching: 2007 pt cruiser oil pressure sensor

You have the right to replace this sensor without draining oil.

You have to lift your vehicle onto jack stands.

*
Let your engine cool off prior to working under your vehicle because the oil sensor switch is hard to reach and also you can burn your skin.

See more: Is The Square Root Of 7 A Rational Number, How To Find The Square Root Of 7

Go under your car and shot to uncover the oil sensor switch. It’s situated to the left the the oil drain plug behind some electrical harness:

*
In the next picture, you have the right to see the sensor connector:

*
With the 15mm wrench, remove the harness assistance (white arrowhead on the following picture):

*
You will have actually you more room to reach the oil sensor
*
To get the wiring off, you must slide the red clip (as show in the next picture):

*

You can push top top the connector and get the wiring off:

*

You deserve to now use the 27mm deep socket to remove the sensor. No so much room come work, for this reason you may use a universal joint and also eventually an extension bar.